Diecoat -180is an insulating coating for the protection of die & core faces and to control the rate of solidification gravity die casting.
In GDC &LPDC,Casting are produced with large /thinner sectioned aluminium alloys.When hot metal (aluminium alloy at 720 C )in cast into die (at 250C) the rate of heat extraction from the metal will be high & as a consequence fluidity of the cast metal will be reduces .Correct use of an insulating coating can control the rate of heat extraction in various parts of the die and so retain fluidity as well as provides a desirable directional solidification pattern in the casting.
Dilute the coating with soft water in the ratio 1:1 (product :water )mix uniformly and apply coating by spraying.The application of the coating is various from very thin where maximum chilling is required and thick on runners and feeders ,thin cast sections etc.Spray the diluted coating on to the die and core faces using a good atomizing gun.The die temperature should be between 120 -200 C so that the spray hits and dries quickly without running.Then re-heated the die to normal working temperature before casting metal.
20 kg Plastic Bucket .
6 Months from date of manufacture.
The product should be stored at room temp..under roof and away from direct sunlight & moisture .